CCNA 3 Final Exam Answers (v+v) – Scaling Networks 1. A network designer is considering whether to implement a swit. View Test Prep – -CCNA 3 Final Exam Answers vv60 Scaling Networks (1).pdf from S at Deakin. CCNA 3 Final Exam Answers CCNA 3 Final Exam V Answers only computer 4 CCNA 2 Final Exam V Answers computer 3 and RTR-A CCNA 1 Chapter 10 V Answers computer 4.
|Published (Last):||20 April 2011|
|PDF File Size:||4.75 Mb|
|ePub File Size:||11.93 Mb|
|Price:||Free* [*Free Regsitration Required]|
July 13, at 2: All switch ports are ccnna to VLAN1. August 9, at 7: Which security protocol or measure would provide the greatest protection for a wireless LAN?
CCNA 3 v6.0 Exam Answers 2018 score 100%
Downloading to the startup-config requires the switch to be reloaded in order for the configuration to take effect. Switches S2 and S3 are properly connected using an ethernet cable. December 28, at 7: Allow all VLANs on the trunk link.
Which two statements are true about the operation of the interfaces? October 18, at 3: This entry can only be removed from the MAC address table by a network administrator.
Which value determines if a switch becomes the central point of reference in the spanning tree topology? June 17, at 3: What should be done to remedy the problem? Configure the VTP mode of the switch to transparent.
Why is it advisable that a network administrator use SSH instead of Telnet when managing anwers Which IP address should be assigned to this new host? What will fix the problem? It is configured in VTP server mode.
An administrator is troubleshooting a PC on the network which is suffering from slow and intermittent connectivity.
CCNA 3 v Exam Answers score %
What is the cause of this problem? SW1 drops the traffic because it is untagged. May 1, at The Layer 2 switching design that is shown has finaal implemented in a campus environment that is using Spanning Tree Protocol. The switch port fails to autonegotiate the duplex setting and defaults to half duplex, which causes a duplex mismatch. When forwarding a frame to the device with address Which STP port type can only appear once on a segment, and must be present in order for traffic to flow on that segment?
It is receiving BPDUs, but not sending data frames.
Module 6 – Anxwers, Sligo. Users complain that they do not have connectivity to the web server that is connected to SW1. December 8, at 9: It restricts broadcast packets to a single VLAN. April 27, at 2: October 17, at 3: March 24, at 9: Users who are assigned to VLAN 10 are connected as shown in the exhibit.
CCNA 3 Final Exam V4.0 Answers
Why does the administrator not detect any changes in the switch configuration after the converted by Web2PDFConvert.
Outside electrical interference has been eliminated. While configuring a new switch, a network administrator configures the switch as an HTTP server.
The network administrator wants to configure a switch to pass VLAN update information to other switches in the domain but not update its own local VLAN database. Verify that the switch has a higher configuration revision number. When the auto-MDIX feature is enabled, the switch detects the required cable type for copper Ethernet connections and configures the interfaces accordingly. Download The Cisco Report Today!
CCNA 3 Final Exam V Answers
The PC has a ping success rate to the default gateway of less than half the ping attempts. The use of higher frequencies means that signals are more likely to be obstructed. January 11, at 8: