AT90S, AT90S Datasheet, AT90S Pin 8MHz 8kb 8-bit Microcontroller, buy AT90S Disclaimer: Whilst information is supplied in good faith, we are not liable for any errors or omissions. Please consult the relevant Atmel datasheet. E&OE. The AT90S is a low-power CMOS 8-bit microcontroller based on the AVR RISC By executing powerful instructions in a single clock cycle, the AT90S
|Genre:||Health and Food|
|Published (Last):||1 March 2014|
|PDF File Size:||3.58 Mb|
|ePub File Size:||5.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
You may also be interested in: The on-chip ISP Flash allows the program memory to be reprogrammed in-system through an SPI serial dataheet or by a conventional nonvolatile memory programmer. In that section, it says:. I have not tested any other controllers, as I have a stock of about s. When you place an order, your payment is made to SeekIC and not to your seller.
If you want to look at the programming lines on an oscilloscope and diagnose the problem, that might allow me to make a firmware datashheet that fixes the problem, but you should probably just use the programmer you have that works. STK never failes at all. Thank you for your fast reply! In Power Save mode, the timer oscillator continues to run, allowing the user to maintain a timer base while the rest of the device is sleeping.
Shop Blog Forum Support. Faithfully describe 24 hours delivery 7 days Changing or Refunding.
AT90S Datasheet(PDF) – ATMEL Corporation
I looked at the two datasheets wide by side and the only difference I can see in the text and the drawing is that on the the RESET pin is shown to be connected to GND! What kind of clock or crystal is the AT90S connected to? The Power Down mode saves the register contents but freezes the oscillator, disabling all other chip functions until the next interrupt or hardware reset. Please create an account or Sign in. I have checked the voltage settings, and tried many combinations.
Freight and Payment Recommended logistics Recommended bank. The resulting architecture is more code efficient while achieving throughputs up to ten times faster than conventional CISC microcontrollers.
All the 32 registers are directly connected to dxtasheet Arithmetic Logic Unit ALUallowing two independent registers to be accessed in one single instruction executed in one clock cycle.
SeekIC only pays the seller after confirming you have received your order. Unfortunately, I do not know what might be going wrong. We have not tested the programmer with the AT90S and I do not know of any customers who have done that either, so there might be trouble getting it to work.
Recent History What is this? We will also never share your payment details with your seller. Margin,quality,low-cost products with low minimum orders.
The frequency matters too, so what frequency is the clock or crystal? I would buy my own AT90S and try to debug this with you, but it seems like it is pretty hard to buy the AT90S online, and according to Atmel, that chip is a mature product and not recommended for new designs. Month Sales Transactions.
I have also at90x8535 with avrdude, it gives me: I tested a board I found with an megaL, and it worked perfectly. I tried changing the crystal to 8MHz, and it did not help, could it be that the delay before the AVR responds is too short for the old dataasheet I am reading the AT90S datasheet and trying to determine what might be going wrong. The complete avrdude command is: In that section, it says: